Stratasys F123 Series Manual page 202

Customer Replaceable Units
Installing the Material Bay
1. Gently install the material bay to the open drawer. See
2. Using a 2.5mm hex wrench, fasten the mounting screws securing the material bay to the
top of the drawer. See
3. Close the material bay drawer.
4. From the back of the printer, connect the cable to the material drive controller board
connector. See
5. Press and hold the locking tab to install the filament tube to the rear of the material bay.
See
6. Open the material bay drawer and view the filament tube from the rear of the printer. Make
sure that the filament tube is routed properly with no interference.
7. Install the rear tool tray.
8. Install the material spool to the material bay.
9. Close and latch the material bay.
10. Close the material bay drawer.
11. Install the rear panel. See
12. Power ON the printer. See
13. Load material. See
Figure
Figure 30 (page
Figure 30 (page 189).
Make sure that there is 0.83 inch of tube from the tube support finger to the
bottom of the switch block assembly. See
Figure 33: Correct material bay material tube installation
"Loading Material" (page
© Copyright 2021 Stratasys. All rights reserved.
32.
189).
"Installing the Rear Panel" (page
"Powering ON the Printer" (page
110).
Figure 32.
Figure 33.
182).
108).
Material Bays
Page 191