Material Bays - Stratasys F123 Series Manual

Customer Replaceable Units
5. Use a 3mm hex wrench to remove the mounting screw (1) that secures the thermistor to
the oven wall. See
6. Remove the thermistor from the printer. See
Installing the Oven Thermistor
1. Align the oven thermistor with its mounting location and use a 3 mm hex wrench to reinstall
the mounting screw (1). See
2. Route the oven thermistor wire through the printer and reconnect it to the I/O board (J36).
3. Reinstall the right rear side panel. See
4. Reinstall the rear panel. See

Material Bays

Required Tools
• 2.5 mm hex wrench
• 3 mm hex wrench
Removing the Material Bay
1. Unload material. See
2. Open the material bay drawer.
3. Unlatch and open the material bay lid.
4. Remove the existing material spool from the material bay.
5. Place the used material spool into an airtight bag and seal it.
Figure 29.
Figure 29: Thermistor Detail
Figure 29.
"Installing the Rear Panel" (page
"Unloading Material" (page
© Copyright 2021 Stratasys. All rights reserved.
Figure 29.
"Installing the Side Panels" (page
114).
Material Bays
184).
182).
Page 188