Stratasys F123 Series Manual page 164

Tip Calibration
e. The calibration part will begin the print process and display the current status on the
f.
g. Press the Next button in the upper-right corner of the page; the Manual Tip Calibration
Up and down
adjustment
buttons for
adjusting the
Z-offset
Sliding scale
icons (4)
User Interface. "HEATING" or "COOLING" is followed by "PREPARING" and then
"PRINTING".
• The Heating/Cooling status displays the current temperature as well as the target
set point.
The amount of time that the printer remains in the Heating/Cooling stage may vary
depending on the current oven chamber temperature.
• The Preparing status will display as the system purges material and detects the
tray level.
• The Printing status displays the number of build layers complete or the amount of
time remaining. Tap the screen to toggle between layers or time.
Once the calibration part is complete "DONE" will be displayed on the User Interface.
Remove the substrate from the platen. You will analyze the part on the substrate to
determine correction values.
After removing the substrate containing the calibration part and closing the oven
door, a message is displayed stating "Is the tray ready for another job?". Press
No to return to the Manual Tip Calibration screen.
page will be displayed.
Figure 9: Manual Tip Calibration Page
© Copyright 2021 Stratasys. All rights reserved.
Manual Tip Calibration
Page 153