Oven Door Gasket - Stratasys F123 Series Manual

Customer Replaceable Units

Oven Door Gasket

Required Tools
• Screwdriver or similar instrument
Removing the Oven Door Gasket
1. Power OFF the printer. See
2. Open the oven door.
3. Extract the gasket pins out of the holes around the entrance to the oven enclosure. See
Figure
4. Pull the ends of the gasket out of the hole below the entrance to the oven enclosure. See
Figure
5. Remove the oven gasket from the printer.
Installing the Oven Door Gasket
1. Insert the gasket pins into the holes around the perimeter of the entrance to the oven
enclosure.
2. Use a screwdriver or similar instrument to poke the ends of the gasket into the hole below
the entrance to the oven enclosure.
3. Close the oven door.
"Powering Off" (page
42.
42.
Figure 42: Oven Door Gasket Detail (door removed for clarity)
© Copyright 2021 Stratasys. All rights reserved.
181).
Oven Door Gasket
Page 200