Stratasys F123 Series Manual page 19

General Information
5
# Item
Leather Printer components may be extremely hot. To prevent burns or other injuries, these gloves
1 Safety should be worn any time you see the gloves safety sign throughout this document. See
Gloves "Product Safety Signs" (page
Needle
Occasionally, you may need to use pliers to aid in the clearing of debris which have
Nose Pliers
2
accumulated on the head and/or tips (see
1
(7 / ")
8
These are used to cut a material spool's filament when unloading and removing materials
3 5" Cutter
from the printer. See
Loupe This tool is included to aid you with performing a Manual Tip Calibration which requires you
4
Magnifier to view small toolpath relationships. See
5 Scraper This tool is used to scrape parts or material off the substrate.
Figure 2: Welcome Kit Contents - Tools
1
Table 2: Key for Figure 2
2).
"Unloading Material" (page
© Copyright 2021 Stratasys. All rights reserved.
4
Description
"Clean/Inspect Tip Wipe Assemblies" (page
114).
"Manual Tip Calibration" (page
Welcome Kit Contents
2
3
176)).
152).
Page 8