Build Status Display; Idle - Stratasys F123 Series Manual

Working with the Build Page

Build Status Display

The Build Status Display section of the Build page is composed of a two-part graphic. The
center portion provides information on a selected and/or building job while the outer progress
ring corresponds with the build information displayed; the information displayed will vary
depending on the state of the printer.

Idle

When the printer is idle, "IDLE" will be displayed within the center of the Build Status Display.
This indicates that the printer is in a state where it is ready to start a build. No progress is
indicated within the outer build progress ring and the time remaining is displayed as zero.
Figure 10: Build Status Display Overview
Build Status
Information
Figure 11: Build Status Display - Idle
© Copyright 2021 Stratasys. All rights reserved.
Build Status Display
Build
Progress
Ring
Page 49