Materials Status - Stratasys F123 Series Manual

Printer Status
portion of the Display Area of the page. Touching one of these icons on the screen will open
that head's Head Details page (see
for the selected head is displayed within the right half of the Head Details page (see
Figure 26 (page
The Head Status Icons can become yellow or red based on the head's odometer (see
Table 6 (page
Materials page when a head is in a warning or error state resulting from odometer related
information (see
yellow coloring indicates a warning, reminding you that the head is reaching its odometer limit.
An icon with red coloring indicates an error, reminding you that the head has exceeded its
odometer limit. You can continue using a head which has exceeded its odometer limit, but it is
highly recommended that you change the head as part quality will be unpredictable. Warning
and error states will be will indicated on the User Interface until the head is replaced, and you
will be required to acknowledge the notification associated with these states prior to the start of
each build.

Materials Status

The current status of each of the material spools installed/inserted into the printer can be
viewed via the Materials page. To locate this information:
1. Press the Materials button within the Navigation Menu; the Materials page will be
displayed.
2. The Display Area of this page contains two or four
depending on printer model.
•
•
65)).
62)). An accompanying warning/error notification will be displayed within the
"Head Warnings" (page 226)
For F170 printers two icons will be displayed. The left icon pertains to the printer's
model material while the right icon pertains to the printer's support material. The
number displayed within the top of the icon indicates which material bay the material
spool is installed/inserted into (1 or 2). The colored bars (displayed within the center of
the icon) and percentage (displayed at the bottom the icon) indicate the current volume
of material on the spool. The name of the type of material on the spool is displayed at
the bottom of the icon.
For F270 and F370 printers four icons will be displayed. The two left-most icons pertain
to the printer's model material while the two right-most icons pertain to the printer's
support material. The number displayed within the top of the icon indicates which
material bay the material spool is installed/inserted into (1 through 4, from left to right).
The colored bars (displayed within the center of the icon) and percentage (displayed at
the bottom the icon) indicate the current volume of material on the spool. The name of
the type of material on the spool is displayed at the bottom of the icon.
© Copyright 2021 Stratasys. All rights reserved.
"Viewing Head Details" (page
and "Head Errors" (page
"Material Status Icons" (page 68)
Materials Status
64)). Odometer information
226)). An icon with
Page 136