Basic Setup
Connecting the Power Cable
To connect the power cable:
1. Connect the male end of the supplied power cord (US or European) directly into a
grounded electrical outlet.
2. Connect the female end of the power cord directly into the socket located on the back of
the printer (see
Configuring the Network
This section is provided in case you need to change your network settings. Within the Network
page you can set your printer's address type to Static, Dynamic (DHCP), or Wi-Fi; Dynamic is
selected by default.
•
Static address - you must enter an IP address, subnet mask, and gateway address for the
printer (provided by the system administrator). Once entered, the address will not change.
Caution
For users in Japan; A power cable is provided for connecting the printer to the AC
electric source. Do not use it with other equipment.
Figure
7).
Warning: Electrical Shock Hazard.
The power cord serves as the disconnect device. The socket outlet must be easily
accessible.
Ethernet Network
Connection (RJ45)
© Copyright 2021 Stratasys. All rights reserved.
Figure 7: Rear Connections
Connecting the Power Cable
Power
Cable
Connection
Page 14