Errors Preventing A Build From Starting - Stratasys Fortus 450mc User Manual

Errors Preventing a Build from Starting

Close the door
• Indicates that the oven door is open.
• Correct condition - close the oven door.
Close the cover
• Indicates that the top cover is open.
• Correct condition - close the top cover.
Load model material
• Model material has not been loaded into the printer.
Correct condition - load model material. See
•
on page 113
Load support material
Support material has not been loaded into the printer.
•
Correct condition - load support material. See
•
Tips" on page 113
Replace empty model canister
Model material canister has run out of material.
•
Correct condition - remove the empty canister and replace with a new canister. See
•
"Removing an empty canister" on page 121
Replace empty support canister
Support material canister has run out of material.
•
Correct condition - remove the empty canister and replace with a new canister. See
•
"Removing an empty canister" on page 121
Change model tip
The model tip has reached its odometer limit (see
•
approximate tip life information). You are unable to continue building using this tip
and must change it prior to starting a build.
Correct condition - remove the tip and replace it with a new one (see
•
Change Wizard" on page 125
page 158
Change support tip
• The support tip has reached its odometer limit (see
approximate tip life information). You are unable to continue building using this tip
and must change it prior to starting a build.
• Correct condition - remove the tip and replace it with a new one (see
Change Wizard" on page 125
page 158
for instructions.
for instructions.
to change tips).
to change tips).
"Loading Material to the Liquefier Tips"
"Loading Material to the Liquefier
for instructions.
for instructions.
Table 3-3 on page 39
and "Changing Tips within the Top Cover" on
and "Changing Tips within the Top Cover" on
239
for
"Using the Tip
Table 3-3 on page 39
"Using the Tip
for