Oven Light - Stratasys F123 Series Manual

Customer Replaceable Units
d. Retain the Y bellows retainers for re-installation.
Back Y Bellows
Installing the Y Bellows
1. Transfer the Y bellows retainers to the new Y bellows.
2. Move the X bridge to the front of the gantry enclosure.
3. Install the front and rear clips (8) that secure the front Y bellows assembly to the X bridge
and oven frame. See
4. Install the rear clips (4) that secure the back Y bellows assembly to the rear of the oven
frame. See
5. Using a 3 mm hex wrench, install the screws (3) that secure the back bellows retainer to
the back of the X bridge assembly tray. See

Oven Light

Required Tools
• 3 mm hex wrench
• Small flathead screwdriver
Removing the Oven Light
1. Power OFF the printer. See
2. Open the oven door.
3. Remove the top gasket pins on both sides of the oven light above the oven enclosure.
Temporarily displace the top of the oven door gasket to access the oven light.
Figure 45: Y Bellows Detail
Clips (12)
Figure 45.
Figure 45.
"Powering Off" (page
© Copyright 2021 Stratasys. All rights reserved.
Front Y Bellows
Figure 45.
181).
Oven Light
Retainer (4)
Page 203