Working with the Tools Page
To configure this setting, press anywhere within the row; the Wifi page will be displayed. Use
the radio buttons within the page to turn the setting On and Off as needed; On is selected by
default.
Camera
The Camera setting gives you control over the printer's camera. When this setting is set to On,
the printer's camera will automatically provide remote monitoring capabilities while a part is
being built. When this setting is set to Off, the camera will be turned off and remote monitoring
capabilities will be disabled.
To configure this setting, press anywhere within the row; the Camera page will be displayed.
Use the radio buttons within the page to turn the setting On and Off as needed; On is selected
by default.
Figure 58: Configure Wifi
Figure 59: Camera
Figure 60: Configure Camera
© Copyright 2021 Stratasys. All rights reserved.
Settings
Page 90