Load/Unload Errors - Stratasys F123 Series Manual

Warnings and Errors
End of support filament detected
• Indicates that filament from the material spool has not been detected by the filament
present switch in the material drive.
• Correct condition - slowly turn the material spool and feed filament into the drive
mechanism. Filament needs to be advanced approximately 2 inches (50.8 mm) to reach
the filament present switch. See
Cooler module not installed
• Indicates that the bead cooler has not been installed with the associated PLA material
head.
• Correct condition - install the bead cooler.

Load/Unload Errors

Timed out
• Indicates that filament was not detected at the head within 5 minutes of a load's initiation.
• Correct condition - remove the material spool and ensure that it is properly prepared for
installation and load. See
Installation" (page 111)
(page
Purge failed
• Indicates that filament is currently in the head, but the load failed.
• Correct condition - unload model and support material (see
(page
loaded, verify that material purges from the tips by performing a manual purge of each tip
using the purge buttons within the Tip Maintenance page (see
(page
Resource not available
• Indicates that the printer is in the process of completing another task and a load/unload
cannot be started until the task is complete.
• Correct condition - wait a couple of minutes and then attempt to load/unload material.
Task already running
• Indicates that the printer is in the process of loading or unloading another bay. Only one
material bay can be loaded or unloaded at a time.
• Correct condition - wait until the load/unload in process is complete before attempting to
load material to or unload material from another material bay.
"Removing Material Spools" (page 116)
for details. Reload the material spool (see
110)).
114)) and then reload these materials (see
65)).
© Copyright 2021 Stratasys. All rights reserved.
"Loading Material" (page 110)
"Loading Material" (page
Load/Unload Errors
for instructions.
and "Material Spool
"Loading Material"
"Unloading Material"
110)). Once
"Head Maintenance"
Page 219