Units - Stratasys F123 Series Manual

Working with the Tools Page
To configure this setting, press anywhere within the row; the First Layer Material page will be
displayed. Use the radio buttons within this page to select between Model and the Default
material, which could be either model or support material. If ABS or ASA material and .005"
slice height are selected, model material is automatically used for the first layer of material.

Units

The Units row displays the type of units the printer is configured for, English (inches) or Metric.
To configure this setting, press anywhere within the row; the Units page will be displayed. Use
the radio buttons within this page to select between English and Metric units; English is
selected by default.
Figure 46: Configure First Layer Material
Figure 47: Units
Figure 48: Configure Units
© Copyright 2021 Stratasys. All rights reserved.
Settings
Page 86