Oven Thermistor - Stratasys F123 Series Manual

Customer Replaceable Units
7. Remove the power supply from the bracket.
Installing the 3.3/5/12 VDC ATX Power Supply
1. Transfer the mounting bracket to the new power supply.
2. Insert the bottom tabs of the power supply bracket into the slotted holes of the electronics
bay panel. Pivot the power supply to its mounting orientation.
3. Use a 3mm hex wrench to reinstall the single mounting screw on top of the power supply
bracket.
4. Connect the power supply cables to the I/O board (J16, J19, J20, J29).
5. Reconnect the input power cable to the 3.3/5/12 VDC ATX power supply.
6. Make sure that the switch on the power supply is in the ON position.
7. Reinstall the rear panel. See

Oven Thermistor

Required Tools
• 3 mm hex wrench
Removing the Oven Thermistor
1. Power OFF the printer. See
2. Remove the rear panel. See
3. Remove the right rear side panel. See
4. Disconnect the thermistor cable from the I/O board (J36).
Figure 28: 3.3/5/12 VDC ATX Power Supply Mounting Location
"Installing the Rear Panel" (page
"Powering Off" (page
"Removing the Rear Panel" (page
© Copyright 2021 Stratasys. All rights reserved.
181).
"Right and Left Side Panels" (page
Oven Thermistor
182).
182).
183).
Page 187