Stratasys F123 Series Manual page 200

Customer Replaceable Units
6. Close the material bay lid.
7. Close the material bay drawer.
8. Power OFF the printer. See
9. Remove the rear panel. See
10. From the rear of the corresponding material bay, press and hold the locking tab to release
the material tube.
11. Disconnect the material tube from the material bay and release the locking tab. See
Figure
12. Disconnect the cable from the material drive controller board connector. See
13. Open the material bay drawer.
"Powering Off" (page
30.
Figure 30: Disconnecting material tube
© Copyright 2021 Stratasys. All rights reserved.
181).
"Removing the Rear Panel" (page
Locking Tab
182).
Material drive controller
board connector
Material Bays
Figure 30.
Page 189