Stratasys F123 Series Manual page 220

Customer Replaceable Units
Installing the Oven Door Latch
1. Using a 2.5 mm hex wrench, install the sensor bracket mounting screws (2) to secure the
sensor mounting bracket to the oven door latch assembly. See
2. Using a 4 mm socket wrench, install the door latch assembly mounting nuts (2) to secure
the door latch assembly inside the oven door assembly. See
3. Connect the door latch assembly sensor cable connectors (2).
4. Install the inside door panel into the door assembly. See
a. Angle the inside door panel slightly and insert the pivot nuts into the lower notches on
b. Gently press down on the door panel until the pivot nuts are fully seated inside the door
c. Rotate the top of door panel toward the door assembly. Gently press in the pivot arms
d. Close the door panel and make sure that the panel and frame mounting holes are
5. Using a 2.5 mm hex wrench, install the inside door panel mounting screws (11). See
Figure 50 (page
6. Close the oven door.
both sides of the door frame.
frame.
to insert them into the upper notches on both sides of the door frame.
aligned.
Figure 53: Inside oven door panel detail
Pivot Arm
Notch
Pivot Nut
Notch
207).
© Copyright 2021 Stratasys. All rights reserved.
Oven Door Latch
Figure 52 (page
Figure 51 (page 208).
Figure 53.
208).
Page 209