ERRORS PREVENTING A BUILD FROM STARTING
Printer busy
Indicates that the printer is in the process of completing another task and a build cannot be started
•
until the task is complete.
•
Correct condition - wait a couple of minutes and then attempt to restart the build.
Close the door
•
Indicates that the oven door is open.
•
Correct condition - close the oven door.
Close the cover
Indicates that the top cover is open.
•
Correct condition - close the top cover.
•
Remove the part
•
Indicates that the completed part from the previously built job is still in the printer's oven chamber.
•
Correct condition - open the oven door and remove the completed part. See
the Printer" on page 129
Select a job
•
Indicates that a job has not been selected for building.
Correct condition - select the job you'd like to build from the Job Queue. See
•
Build" on page 122
Insert a model head
•
Indicates that a model head has not been installed into the printer.
Correct condition - install model head. See
•
Insert a support head
•
Indicates that a support head has not been installed into the printer.
•
Correct condition - install support head. See
Model head not communicating
•
Indicates that model head is not enabled/communicating. This will only be displayed when the top
cover is closed.
•
Correct condition - open the top cover and unclip the head cable from the model head. Wait a few
seconds and then reconnect the head cable to the model head and close the top cover (see
Replacement" on page 117
head or the head cable; please contact Stratasys Customer Support or your regional Stratasys office
for further assistance (see
Support head not communicating
•
Indicates that support head is not enabled/communicating. This will only be displayed when the top
cover is closed.
Correct condition - open the top cover and unclip the head cable from the support head. Wait a few
•
seconds and then reconnect the head cable to the support head and close the top cover (see
Replacement" on page 117
head or the head cable; please contact Stratasys Customer Support or your regional Stratasys office
for further assistance (see
for instructions.
for instructions.
for details). If the error persists there is likely a problem with either the
"Getting Help" on page 204
for details). If the error persists there is likely a problem with either the
"Getting Help" on page 204
"Head Replacement" on page 117
"Head Replacement" on page 117
for contact information).
for contact information).
207
"Removing a Part from
"Selecting a Job to
for instructions.
for instructions.
"Head
"Head