Stratasys F123 Series Manual page 215

Customer Replaceable Units
4. Using a 3mm hex wrench, remove the oven light mounting screws (2) and the retaining
bracket. See
5. Move the oven light out a small distance to access the oven light cable connector.
6. Disconnect the oven light cable connector and remove it from the printer. If necessary, use
a small flathead screwdriver to disengage the cable connector tabs. See
Cable
Connector
Tabs
Installing the Oven Light
1. Connect the loose cable connector to the oven light. Orient the cable with the green wire
toward the center of the light. See
Figure 46.
Figure 46: Oven Light Detail
Figure
Figure 47: Oven Light Cable Detail
Note green wire
orientation
© Copyright 2021 Stratasys. All rights reserved.
Oven light
47.
Oven Light
Figure 46.
Retaining Bracket
Page 204