Calibration And Adjustments; Tip Calibration - Stratasys F123 Series Manual

Tip Calibration

6 CALIBRATION AND
ADJUSTMENTS
This chapter describes basic calibration and adjustment procedures for the F123 Series. The
buttons/pages described within this chapter are accessible via the Calibration page.
To open the Calibration page, press the Tools button within the Navigation Menu; the Tools
page will be displayed (see
select the Calibration button; the Calibration page will be displayed.
Tip Calibration
The printer's calibration status will be displayed within the Tip Calibration row. Calibrated or
Not Calibrated will be displayed depending on the printer's calibration status.
Pressing anywhere within the Tip Calibration row will open a page allowing you to select from a
variety of tip calibration options. You cannot build parts on the printer until the printer's tips are
calibrated.
"Working with the Tools Page" (page
Figure 1: Calibration page
Figure 2: Tip Calibration
© Copyright 2021 Stratasys. All rights reserved.
78)). Within the Tools page
Page 148