Network Address Configuration - Stratasys F123 Series Manual

Basic Setup
• Dynamic address (DHCP) - a network server or PC will generate an IP address for the
printer. A different IP address may be generated from time to time by the server or PC.
• Wi-Fi address - the printer will scan for and allow you to connect to an available Wi-Fi
network (if the Wi-Fi dongle has been installed).

Network Address Configuration

To configure your printer's network address settings:
1. Power ON the printer, see
2. Open the Tools page by pressing the Tools button within the Navigation Menu (see
Table 1 (page
3. Open the Network page by pressing the Network button within the Tools page (see
Figure 36 (page
4. The Connection Type row allows you to select between a wired or wireless network. The
option selected will determine the configurable settings displayed within the Network page.
•
•
5. After selecting the radio button corresponding to the connection type you'd like to use
(wired or wireless) press the Back button in the upper-left corner of the page to return to
the Network page.
6. For wired networks:
a. The Network Mode row will be displayed. Press anywhere within this row.
b. Select either the Static or Dynamic radio button to enable that network address type.
42)).
79)).
Selecting the Wired option will allow you to select between a Dynamic or Static network
mode.
Selecting the Wireless option will configure the pinter to use a Wi-Fi network. You will
need to scan for a wireless network and enter the security settings for the selected
network (if required) to complete the configuration. Please note that the availability of
the Wireless option depends upon the configuration purchased with your printer.
Depending on the option selected, you may need to configure additional information
within the Network page.
© Copyright 2021 Stratasys. All rights reserved.
"Powering ON the Printer" (page 108)
Figure 8: Wired Network Selection
Configuring the Network
.
Page 15