Exporting System Configuration (.Cfg) File - Stratasys F123 Series Manual

Exporting System Configuration (.CFG) File

9. Once the software upgrade is successfully downloaded to the printer an indicator will be
displayed within the bottom of the Control Center window.
10. The touchscreen will refresh to indicate that the printer is verifying the upgrade file.
11. Once the verification process is complete, the printer will automatically reboot and begin
installing the upgrade file. A variety of output will be displayed on the touchscreen during
the installation process.
12. Once the Controller Software upgrade is installed the printer will conduct its regular startup
process and automatically perform an XY Gantry Calibration (see
Printer" (page 108)
Exporting System Configuration (.CFG) File
If your system is receiving fault determination codes, you may need to export a configuration
(.cfg) file from your system to send to Customer Support. System configuration files can be
exported using one of the following three methods:
• Saving to a USB Flash drive directly from the F123 Series printer
• Saving to a location on your workstation PC using the Insight software application
• Saving via GrabCAD Print
You have the option of exporting system configuration files via any of these methods; however,
the USB Flash drive method is the preferred method.
Figure 10: Software Upgrade Successfully Downloaded
The verification process will take several minutes; please be patient.
Figure 11: Verifying Software Upgrade
The installation process will take several minutes; please be patient.
for details).
© Copyright 2021 Stratasys. All rights reserved.
Insight Software Method (F370 only)
"Powering ON the
Page 170