Customer Replaceable Units
4. Rear side panels only: The rear side panels are held in place by a standoff that is retained
inside the printer frame. Slide the panel away from the printer to disengage the retaining
standoff. See
5. Remove the side panel from the printer.
Installing the Side Panels
1. Insert the side panel retaining standoff into the hole in the printer frame and slide the panel
into place until it aligns with the mounting screw holes. See
2. Use a 5 mm hex wrench to reinstall the mounting screws (6). See
Front Top Cover
Required Tools
•
2 mm hex wrench
Removing the Front Top Cover
1. Power OFF the printer. See
2. Open the oven door to release the front top cover latch.
3. Open the front top cover.
Figure
25.
Figure 25: Rear Side Panel Retaining Standoff Detail
"Powering Off" (page
© Copyright 2021 Stratasys. All rights reserved.
Retaining Standoff
Figure
25.
Figure
181).
Front Top Cover
24.
Page 184