Stratasys F123 Series Manual page 219

Customer Replaceable Units
5. Disconnect the door latch assembly solenoid cable connector.
6. Disconnect the door latch assembly sensor cable connectors (2).
7. Using a 4 mm socket wrench, remove the door latch assembly mounting nuts (2). See
Figure
8. Remove the door latch assembly from the oven door. See
9. Using a 2.5 mm hex wrench, remove the sensor bracket mounting screws (2). See
Figure
10. Remove the sensor and bracket from the latch assembly and retain them for re-installation.
See
51.
Figure 51: Door latch assembly mounting nut locations
52.
Figure 52.
Figure 52: Door latch sensor mounting bracket detail
© Copyright 2021 Stratasys. All rights reserved.
Oven Door Latch
Figure 51.
Page 208