General Information
The following items are not located within the Welcome Kit. Instead, they reside within the oven
chamber and the storage drawer. The items found within the oven chamber must be removed
before turning the printer power on.
#
Item
1 Substrate (x16)
ABS Model Material
2
Spool
QSR Support
3
Material Spool
Figure 4: Additional Components - Startup Materials
1
6
Table 4: Key for Figure 4
A substrate is the surface upon which a part is built. The same substrate is used for
all model materials, including PLA. See
information.
Material spool containing 60 in
Used" (page
37)).
Material spool containing 60 in
Used" (page
37)).
© Copyright 2021 Stratasys. All rights reserved.
2-5
7
8
Description
"Preparing the Printer" (page 122)
3
(984 cc) of ABS model material (see
3
(984 cc) of QSR support material (see
Welcome Kit Contents
9
for more
"Materials
"Materials
Page 10