Handling/Storing Materials - Stratasys F123 Series Manual

Unloading Material
•
•
•

Handling/Storing Materials

Stratasys FDM thermoplastic materials will maintain proper product performance over an
extended period of time, when handled and stored according to recommended procedures.
Like other thermoplastics, the filament can absorb moisture when exposed to ambient
humidity. Stratasys material spools are designed to minimize moisture exposure while
unopened and opened. When a spool's filament absorbs moisture a finished part's surface
quality, seam quality, and overall part aesthetics can be affected. Care should be taken to
ensure filament remains dry.
Two model material spool sizes are available. Standard model material spools hold 60 in
(984 cc) of filament while large spools hold 90 in
available. Support material spools hold 60 in
Material spools also contain desiccant material; the desiccant is designed to maintain proper
moisture levels for an unopened spool. Once the desiccant is exposed to ambient air, it can
become saturated and ineffective for moisture control. Proper handling of the spool after it has
been opened is essential to maximizing material life. A plastic bag provides an airtight seal to
keep moisture from entering the material spool while stored.
If a material spool with material remaining on the spool is removed from the printer, it should be
stored within one of the airtight bags provided within the Welcome Kit. Prior to placing the
material spool into the bag, ensure that the spool's filament is securely snapped into place
within one of the filament tail capture locations on the edge of the spool.
Within the Material Details page text will be displayed indicating the cause of the load
error. Touching this text on the screen may display a dialog with additional information
pertaining to the error.
of the various load errors you may encounter, as well as instructions for correcting the
error condition.
Once the error is resolved, return to the Build page.
Press the Play button to resume building or press the Abort button to cancel the build.
Caution:
Material storage shall be in the range of 55°F to 86°F (13°C to 30°C), with relative
humidity less than 70%.
Caution:
A material spool should not remain outside of a sealed container for longer than
1 minute. A foil bag or a material bay are examples of acceptable containers.
© Copyright 2021 Stratasys. All rights reserved.
"Load/Unload Errors" (page 219)
3
(1475 cc). One support material spool size is
3
(984 cc) of filament.
Handling/Storing Materials
provides detailed descriptions
3
Page 118