Stratasys F123 Series Manual page 27

Basic Setup
•
•
If the Static option is enabled, you must manually configure the IP Address, Subnet
Mask, and Gateway Address fields.To configure this information simply touch a field on
the screen to select it and then use the keypad displayed to enter address information.
i. Touch anywhere on the screen outside of the keypad to exit and close the keypad.
Figure 9: Static Network Configuration
ii. Scroll to the bottom of the page and press the Apply button when finished to save
the network configuration.
iii. Press the Back button in the upper-left corner of the page to return to the Network
page.
If the Dynamic option is enabled, no additional configuration is necessary as a network
server or PC will automatically generate an IP address for the printer. A different IP
address may be generated from time to time by the server or PC; the generated IP
address will be displayed within the IP Address field of the Network page, and
corresponding Subnet Mask and Gateway Address information will also be displayed.
© Copyright 2021 Stratasys. All rights reserved.
Figure 10: Apply Changes Button
Configuring the Network
Page 16