Customer Replaceable Units
7. Remove the blower assembly from the printer. See
Installing the Oven Blower Assembly
1. Using a 3 mm hex wrench, reinstall the blower assembly mounting screws (5). See
Figure
2. Make sure the blower motor cable is routed properly and secured with tie wraps.
3. Reconnect the fan blower motor cable connector to the I/O board (J39 - right blower,
J37 - left blower).
4. Right-side oven blower only: Using a 2.5 mm hex wrench, reinstall the mounting screws
(2) that secure the side bezel to the printer.
5. Reinstall the side panels. See
6. Reinstall the rear panel. See
Right side oven blower shown only. The left side blower procedure is identical to
the right.
Figure 41: Right Side Blower Assembly Mounting Screw Locations
41.
© Copyright 2021 Stratasys. All rights reserved.
"Installing the Side Panels" (page
"Installing the Rear Panel" (page
Right and Left Side Oven Blowers
Figure
41.
184).
182).
Page 199