Stratasys F123 Series Manual page 236

Warnings and Errors
Model head removed
• Indicates that the printer lost contact with the model material spool's memory chip or the
material drive controller inadvertently lifted.
• Correct condition - ensure that the material spool is seated correctly within the material
drive. If so, remove the spool and then reinstall it (see
(page 116)
remove the spool and install a new spool.
Support head removed
• Indicates that the printer lost contact with the support material spool's memory chip or the
material drive controller inadvertently lifted.
• Correct condition - ensure that the material spool is seated correctly within the material
drive. If so, remove the spool and then reinstall it (see
(page 116)
remove the spool and install a new spool.
File not found
• Indicates that the printer was unable to locate the job file that was selected for building.
This error pertains to job files loaded via USB flash drive only.
• Correct condition - ensure that the USB flash drive containing the selected job file is
securely inserted into one of the USB ports within the interface panel (see
Figure 3 (page 24)
the printer's USB ports select the file you'd like to build by loading it to the Job Queue (see
"USB Method" (page
Unknown error
• An unexpected error occurred in which the printer was unable to map the cause of the error
to a known abort reason.
• Correct condition - attempt to restart the build, see
instructions. If the error persists, contact Stratasys Customer Support or your regional
Stratasys office (see
and "Material Spool Installation" (page
and "Material Spool Installation" (page
for port locations). Once the flash drive is securely inserted into one of
54)).
"Getting Help" (page 214)
The warnings and errors listed below are displayed within the notifications area of the
Head Details page. See
© Copyright 2021 Stratasys. All rights reserved.
111)). If this does not correct the error,
111)). If this does not correct the error,
"Basic Job Build Tasks" (page 121)
for contact information).
"Viewing Head Details" (page 64)
Build Abort Errors
"Removing Material Spools"
"Removing Material Spools"
for details.
for
Page 225