Stratasys F123 Series Manual page 234

Warnings and Errors
Support filament broken
• Indicates that the sensor in the material drive controller is not detecting the support filament
and the material volume on the spool is large enough that the filament probably broke
rather than ran out. This can also be caused by spool axles being interchanged between
different spools or by the system improperly calculating used filament volume.
• Correct condition - remove the material spool and clear all filament from the filament tubes
(see
switch in the material bay may be defective. Replace the material bay (see
(page
(page
reboot the printer. If the error persists, contact Stratasys Customer Support or your regional
Stratasys office (see
No material detected in support head
• Indicates that the support head motor is not detecting filament presence although the
material on the spool has not run out and filament is still detected by the material drive
controller.
• Correct condition - open the top cover. Access the Head Maintenance page (see
Maintenance" (page
support head. If unsuccessful, attempt a full unload of support material (see
Material" (page
Material" (page
Material Spools" (page 116)
support head if no resolution is found (see
"Removing Material Spools" (page
188)). If the spool is empty, replace it with another spool (see
110)). If the error is not resolved, check the job log for any zero volume jobs and
"Getting Help" (page 214)
65)) to perform a purge while manually feeding filament into the
114)). Inspect the Y-block or I-block. Reload support material (see
110)). If the warning persists, replace the support spool (see
© Copyright 2021 Stratasys. All rights reserved.
116)). If the spool is not empty, the filament present
for contact information).
and "Material Spool Installation" (page
"Head Replacement" (page
Build Pause Warnings
"Material Bays"
"Loading Material"
"Head
"Unloading
"Loading
"Removing
111)). Replace the
119)).
Page 223