Part Build Location - Stratasys F123 Series Manual

Changing Printer Defaults

Part Build Location

The Part Placement setting determines whether or not you can select a job's placement on a
substrate prior to starting the build (see
To configure this setting, press anywhere within the Part Placement row; the Part Placement
page will be displayed. Use the radio buttons within this page to turn the setting On and Off as
needed.
By default this setting is set to On, meaning you will be able to select a job's location on the
substrate prior to starting the build (see
build the Part Placement dialog will be displayed asking you to select the part's build location
(see Figure 21 (page
as well as a blue bounding box graphic (the imaginary box surrounding the part). You can
select the part's build location by dragging and dropping the bounding box on the touchscreen;
the bounding box cannot be placed outside the limits of the platen. Pressing the Print button
will confirm your selected placement and start a build.
"Ghost box" graphics are also displayed; a "ghost box" represents the location where a part
was built previously. Pressing the Clear History button will clear the display, removing all
"ghost box" items.
"Part Placement" (page
Figure 20: Configure Part Placement
"Selecting a Job to Build" (page
133)). The dialog will contain a graphic representing your printer's platen
© Copyright 2021 Stratasys. All rights reserved.
Part Build Location
84)).
123)). At the start of a
Page 132