Right And Left Side Panels - Stratasys F123 Series Manual

Customer Replaceable Units

Right and Left Side Panels

Required Tools
• 5 mm hex wrench
Removing the Side Panels
1. Power OFF the printer, see
2. Remove the rear panel. See
3. Using a 5 mm hex wrench, remove the side panel mounting screws (6 on each panel). See
Figure
"Powering Off" (page
24.
Figure 24: Side Panel Mounting Screw Locations
© Copyright 2021 Stratasys. All rights reserved.
181).
"Removing the Rear Panel" (page
Right and Left Side Panels
182).
Page 183