Oven Door Camera - Stratasys F123 Series Manual

Customer Replaceable Units
2. Tuck the excess cable into the bezel opening and push the oven light into its mounting
position. If necessary, pull the cable from inside the gantry to remove slack.
3. Insert the oven light into the opening above the oven enclosure.
4. Using a 3mm hex wrench, install the retaining bracket and oven light mounting screws (2).
See
5. Reinstall the top gasket pins on both sides of the oven light.
6. Close the oven door.
7. Power ON the printer.

Oven Door Camera

Required Tools
• 3 mm hex wrench
Removing the Oven Door Camera
1. Power OFF the printer. See
2. Open the oven door.
3. Using a 3mm hex wrench, remove the camera assembly mounting screw (1) through the
hole in the top of the oven door. See
4. Gently move the camera assembly out a small distance and disconnect the cable on the
back of the camera.
Figure 46 (page 204).
Do not touch the camera lens. If necessary, wipe the camera lens with a clean
microfiber cloth.
© Copyright 2021 Stratasys. All rights reserved.
"Powering Off" (page
Figure 48 (page
Oven Door Camera
181).
206).
Page 205