Customer Replaceable Units
14. Using a 3mm hex wrench, remove the screws (3) that secure the rear tool tray. Remove the
rear tool tray.
15. Using a 2.5mm hex wrench, remove the material bay mounting screws (2). See
16. Gently tilt and lift the material bay to remove it from the open drawer. See
Caution:
Be careful not to damage the spool interface board on the side of the material bay.
Figure 32: Material Bay Removal
© Copyright 2021 Stratasys. All rights reserved.
Figure 31: Rear tool tray
Material Bays
Figure
32.
Figure
32.
Page 190