Rear Top Cover - Stratasys F123 Series Manual

Customer Replaceable Units
4. Using a 2 mm hex wrench, remove the hinge mounting screws (4) from the crossbar. See
Figure
5. Lift the front top cover up and away from printer to remove.
Installing the Front Top Cover
1. Align the front top cover hinges with the mounting locations on the crossbar. See
2. Using a 2mm hex wrench, reinstall the hinge mounting screws (4). See
3. Close the front top cover.

Rear Top Cover

Required Tools
• 2.5 mm hex wrench
Removing the Rear Top Cover
1. Power OFF the printer. See
2. Open the oven door to release the top cover latch.
3. Open the front top cover.
4. Using a 2.5 mm hex wrench, remove the screws (2) that secure the rear top cover to the
cross bar.
26.
Figure 26: Front Top Cover Hinge Mounting Screw Locations
"Powering Off" (page
© Copyright 2021 Stratasys. All rights reserved.
181).
Rear Top Cover
Figure 26.
Figure 26.
Page 185