Grabcad Print Method; Insight Software Method (F370 Only) - Stratasys F123 Series Manual

Updating Controller Software

GrabCAD Print Method

To update Controller Software via GrabCAD Print, navigate to
196-printer-firmware-management
firmware".

Insight Software Method (F370 only)

If the printer has a weak network connection or does not allow for automatic updates, you can
manually download Controller Software updates by performing the following steps:
1. Open the Maintenance page by pressing the Maintenance button within the Tools page
(see
2. Locate the Update Software row within the page. Press anywhere within the row to open
the Update Software page (see
3. The Update Software page will open and the printer will automatically be put into software
upgrade mode, allowing it to receive the software upgrade. The following is displayed on
the touchscreen while the printer is in software upgrade mode.
4. From your workstation PC's Start Menu, navigate to All Programs > Insight (installed
version) > Control Center (installed version) or double-click the Control Center shortcut (if
available).
Figure 36 (page 79)).
Figure 7: Printer In Software Upgrade Mode
All recent calibration data (i.e. tip offset values) as well as printer settings and
configurations are automatically retained during the software upgrade process.
Files sent to the Job Queue via Ethernet or Wi-Fi connection or transferred to the
printer from a USB flash drive are not retained.
© Copyright 2021 Stratasys. All rights reserved.
and follow the procedure for "Updating the printer's
Figure 75 (page 98)).
GrabCAD Print Method
http://help.grabcad.com/article/
Page 168