Y Blocks - Stratasys F123 Series Manual

Customer Replaceable Units

Y Blocks

Required Tools
• 3 mm hex wrench
Removal Procedure
1. Unload material.
2. Power OFF the printer, see
3. Disconnect material tubes at Y block by loosening the compression fittings and pulling the
tubes outward. See
4. Using a 3 mm hex wrench, remove the Y block mounting screws (2). See
Figure 55 (page
Y block removal is the same for both Y blocks. Removal of the model material Y block
is depicted in this procedure.
Figure 54.
Figure 54: Disconnecting Material Tubes from Y Block
211).
© Copyright 2021 Stratasys. All rights reserved.
"Powering Off" (page
Loosen compression fitting to
pull material tubes outward
181).
Y Blocks
Page 210