Customer Replaceable Units
Customer Replaceable Units
The following service procedures outline the replacement instructions for the customer
replaceable units of the F123 Series printers.
Powering Off
Powering OFF the Printer
1. Depress the Power button (see
2. Press Accept on the touchscreen display.
3. Wait approximately 25 seconds for the printer to power down.
4. Remove the AC power cord from the rear of the system.
Warning: Electrical Shock Hazard.
Power OFF the printer and disconnect the power cord before replacing any of the
customer replacement units.
Figure 22: AC power cord location
© Copyright 2021 Stratasys. All rights reserved.
Figure 1 (page 108)
for button location).
Powering Off
Page 181