Stratasys F123 Series Manual page 231

Warnings and Errors
Insert filament
• Indicates that the sensor in the material drive controller is not detecting filament. This could
indicate that the material spool is empty or filament became broken during the load
process.
• Correct condition - remove the material spool and clear all filament from the filament tubes
(see
Material" (page
regional Stratasys office (see
Insert spool
• Indicates that a material spool has not be installed into the material bay for which you are
attempting to load material.
• Correct condition - install a material spool. See
instructions.
Invalid material
• Indicates that the installed material is not licensed for use with the printer.
• Correct condition - to adjust your printer's material license please contact Stratasys
Customer Support or your regional Stratasys office (see
contact information).
Cannot load model in to support head
• Indicates that you have installed a model spool into the wrong location within the material
bay.
• Correct condition - Remove the model spool from its current location within the material
bay and insert it into a model material bay. For printers with two operating material bays,
the model bay is the left bay. For printers with four operating material bays, the model bays
are the two left-most bays. See
Cannot load support in to model head
• Indicates that you have installed a support spool into the wrong location within the material
bay.
• Correct condition - Remove the support spool from its current location within the material
bay and insert it into a support material bay. For printers with two operating material bays,
the support bay is the right bay. For printers with four operating material bays, the support
bays are the two right-most bays. See
Cannot change material type during build
• Indicates that the printer is currently in the process of building and you are attempting to
change model or support material during the build.
• Correct condition - you cannot change material types while the printer is in the process of
building a part. Wait until the build is complete before changing materials.
"Removing Material Spools" (page
110)). If the error persists, contact Stratasys Customer Support or your
© Copyright 2021 Stratasys. All rights reserved.
116)). Reload the material spool (see
"Getting Help" (page 214)
"Material Spool Installation" (page 111)
Figure 11 (page 31)
Figure 11 (page 31)
Load/Unload Errors
for contact information).
"Getting Help" (page 214)
for details.
for details.
"Loading
for
for
Page 220