Touchscreen Display - Stratasys F123 Series Manual

Customer Replaceable Units
Installing the Head Ribbon Cables
1. Install the rear ribbon cable bracket to cutouts at the back, top of the printer frame. See
Figure 36 (page
2. Using a 3 mm hex wrench install the mounting screws (3) to fasten the front ribbon cable
bracket to the back of the toggle assembly. See
3. Connect the rear head ribbon cable connectors (2) to the I/O board (J6 and J7). See
Figure 34 (page
4. Connect the front head ribbon cable connectors (2) to the material and support heads. See
Figure 34 (page
5. Install the rear panel. See
6. Close the top cover.

Touchscreen Display

Required Tools
• 3 mm hex wrench
Removing the Touchscreen Display
1. Power OFF the printer. See
2. Using a 3 mm hex wrench, remove the mounting screw (1) that secures the touchscreen to
the display panel bracket. See
3. Gently lift the touchscreen slightly to disengage the standoff fasteners (4) from the display
panel bracket. See
4. While supporting the touchscreen, tilt it away from the bracket to disconnect the touch
extender cable and the display cable from the back of the display.
194).
193).
193).
"Installing the Rear Panel" (page
Caution:
The connectors and cables of the touchscreen display are fragile. Excessive force
may cause damage to connector pins or wiring.
"Powering Off" (page
Figure 38 (page
The flat display cable connector is fragile. Simultaneously pull both corners of the
connector straight out, without rocking back and forth.
© Copyright 2021 Stratasys. All rights reserved.
Figure 35 (page
181).
Figure 38 (page 196).
196).
Touchscreen Display
193).
182).
Page 195