About The Sample Queue - Stratasys F123 Series Manual

Working with the Queue Page

About the Sample Queue

The printer comes with several sample job files permanently installed on its hard drive. These
files are accessible via the Sample Queue. This queue is composed of a few sample part files
as well as a variety of other files that are helpful for testing the printer. The majority of the files
within the Sample Queue will be utilized only by authorized service representatives when
performing maintenance on the printer. To access the Sample Queue:
1. Navigate to the Queue page by pressing the Queue button within the Navigation Menu.
2. Press the Load File button in the upper-right corner of the touchscreen (see
Figure 15 (page 55)
3. The Load File page will be displayed; press the Internal Storage button within this page.
The list of sample jobs contained within the Sample Queue will be displayed.
Overall, the functionality of the Sample Queue is the same as that of the Job Queue:
• Additional details for a job can be viewed by opening its Job Details page.
• Within the Job Details page you can view the specifics of the job including build time,
author, material requirements, number of layers, slice height, and Insight version that the
job was compiled with.
• Pressing the Zoom In button within the page will provide a detailed view of what the job will
look like once it has been successfully built. Pressing the Zoom Out button will close this
view and return you to the Job Details page.
• Pressing the Print button within the Job Details page will select the job for building.
However, the following functionality differences exist for the Sample Queue:
• "Job Queue Controls" (page 58)
job files cannot be deleted.
• Jobs in the Sample Queue cannot be sorted (as described in
(page
for button location).
Figure 24: Load File Page - Internal Storage Option
57)).
© Copyright 2021 Stratasys. All rights reserved.
are disabled for the Sample Queue, and therefore these
About the Sample Queue
"Editing the Job Queue"
Page 60