Warnings And Errors; Warnings At Build Start - Stratasys F170 User Manual

WARNINGS AND ERRORS

If the printer detects an issue that may affect a build, it will be indicated within the Notifications Display portion of
the Build Page. A yellow or red notification badge icon will be displayed, depending on the severity of the
warning/error, along with text indicating the reason(s) for the warning. Touching the text on the screen will open
a dialog indicating the reason(s) for the notification, and in some cases, steps to correct the notification (see
Figure 4-4 on page 41).
Depending on the type of warning/error, a notification badge icon may also be displayed within the
Page. The Materials button will be displayed in its warning state within the Navigation Menu to indicate the
warning (see Table 4-1 on page
the center of the Material Status Icon experiencing the warning/ error (see
notification badge icon on the screen will open the corresponding material's Materials Details page and provide
information indicating the cause of a warning/error (see

WARNINGS AT BUILD START

Model material does not match selected job
• The model material currently installed does not match the model material configuration of the
selected job.
• Correct condition - unload incorrect model material and load the correct model material for the
selected job. See
instructions.
Support material does not match selected job
• The support material currently installed does not match the support material configuration of the
selected job.
• Correct condition - unload incorrect support material and load the correct support material for the
selected job. See
instructions.
Insufficient model material for part build
The amount of model material currently installed in the printer is not sufficient for the selected build.
•
• Correct condition - install additional model material into the printer, see
page 108 for instructions. When installing additional material you can install a second material spool
in order to utilize the auto changeover feature or install an entirely new spool containing enough
material to complete the build. Please note that auto changeover is only applicable for the F270 and
F370 printers.
Insufficient support material for part build
The amount of support material currently installed in the printer is not sufficient for the selected build.
•
Correct condition - install additional support material into the printer, see
•
page 108 for instructions. When installing additional material you can install a second material spool
in order to utilize the auto changeover feature or install an entirely new spool containing enough
material to complete the build. Please note that auto changeover is only applicable for the F270 and
F370 printers.
Order new model head
The model head has reached 1350 build hours, and is near its odometer limit. Build hours are
•
available within the head's Head Details page (see
• Correct condition - you are still able to build using this head, but part quality may be affected. Once
the head's odometer limit is reached, you will be prompted to change the head (see
Replacement" on page
39). Within the Materials page a notification badge icon will be displayed over
"Unloading Material" on page 113
"Unloading Material" on page 113
117).
Table 4-7 on page
Figure 4-29 on page
and "Loading Material" on page 108
and "Loading Material" on page 108
"Viewing Head Details" on page
205
66). Touching the
69).
"Loading Material" on
"Loading Material" on
63).
"Head
Materials
for
for