Build Job Warnings - Stratasys Fortus 360mc User Manual

3.
If
will initiate (an Auto Z Stage Zero may be performed depending upon
modeler status or settings).
4.
If
choices:
Note: For more information about User Placement on Platen
see
A.
B.

Build Job Warnings

If the system detects an issue that may affect a job build, it displays one of the
following warnings:
1.
Head has been changed. Consider tip calibration
• Indicates a new head has been installed.
• Run and verify a calibration part before building jobs. See
2.
Change Model (or Support) Canister to ABS
• Indicates a mis-match between loaded material and material for which the
• Replace the flagged material canister with proper type.
3.
Need More Model (or Support) Mat'l (9.1
• The total available material is less than the estimated amount for the part
• If the system runs out of material before part completion, system will
• Replace flagged material canister.
• Press ENTER to select the job for build.
• For more information on the sample job queue, see
Job Queues" on page
User Placement on Platen
User Placement on Platen
"Display Units" on page
>Locate Part Start..
Demo Bounding Box
Continue..
Select
Demo Bounding Box
part build start location.
Select
Continue..
Offset - Manual Start" on page
part (CMB) file was processed.
(CMB file).
pause the build until material is added.
4-29.
is set to
NO
is set to
YES
4-30.
or
Locate Part Start
to initiate the part build.
6-10.
4-7
"Working with the
(system default), the part build
, you are offered the following
to view or change the
"XY and Z Tip
(or other material)..
more)..