Right And Left Side Panels - Stratasys F170 User Manual
F123 series shared office 3d printers
Hide thumbs
Also See for F170:
- Operation and maintenance manual (91 pages) ,
- Site preparation manual (22 pages)
Table of Contents
Advertisement
RIGHT AND LEFT SIDE PANELS
Required Tools
5 mm hex wrench
•
Removing the Side Panels
1.
Power OFF the printer, see
2.
Remove the rear panel. See
3.
Using a 5 mm hex wrench, remove the side panel mounting screws (6 on each panel).
See
Figure
7-12.
Figure 7-12:
"Powering Off" on page
"Removing the Rear Panel" on page
Side Panel Mounting Screw Locations
169.
170.
171
Advertisement
Table of Contents
