Table of Contents
Advertisement
Stratasys J826 User Guide
Cleaning the Exterior Panels
The painted exterior plastic panels of the printer has a durable finish, offering
excellent chemical resistance to common cleaning materials. Follow the
recommendations below when cleaning these areas of the printer.
Acceptable Cleaning Agents
• mild soap solution
• common household cleaners and window cleaners
• common commercial and industrial detergents, 5% solution in water
• alcohol (ethanol, isopropanol), 10% to 40% solution in water
Wipe the exterior of the printer, using a soft cloth moistened with the cleaning
solution.
Unacceptable Materials
• industrial solvents
• cleaning agents containing hydrocarbons, ketones, esters and lacquer
thinners
• spray disinfectants
• abrasives and agents which could wear away the panel finish
Cleaning the UV Screen
The transparent section of the cover is made of strong, acrylic material that
screens out harmful UV radiation. Use extreme care when cleaning it to
prevent the appearance of scratch marks.
Caution
Do not use abrasive cleaners or cleaning fluids containing ammonia,
alcohol, acetone, benzine, carbon or tetrachloride. These materials can
cause permanent damage to the surface.
To clean the UV screen:
1. Blow off surface dust.
2. Prepare a 1-percent solution of mild dish-washing soap in water—about
3. Soak a micro-fiber cloth in the solution.
4. Thoroughly wet the surface with the cloth. Do not wipe!
5. Rinse the cloth with clean water.
DOC-28000 Rev. I
Do not wipe the surface to remove dust; this might scratch the surface.
two teaspoons (10 ml) in a liter of water.
Note: While soapy water is effective for cleaning, commercial products are also
available for cleaning acrylic surfaces (for example, Novus
These products give the surface antistatic, smudge and scratch-resistant
properties.
Do not use paper towels, which can cause scratch marks.
4 Operating and Maintaining the Printer
®
and Brillianize
®
).
4-134
Advertisement
Table of Contents
