Customer Replaceable Units
4. Tighten the rear panel mounting screws (10) in the order shown in
Torque to 21 in-lbs.
5. Tighten the rear panel mounting screws (16).
Right and Left Side Panels
Required Tools
•
3 mm hex wrench
Removing the Side Panels
1. Power OFF the printer, see
2. Remove the rear panel. See
3. Open the oven door to release the top cover latch.
4. Open the top cover.
5. Using a 3 mm hex wrench, remove the side panel mounting screws (2). See
Figure 18 (page
Figure 17: Rear Panel Screw Installation Order
1
2
"Powering Off" (page
"Removing the Rear Panel" (page
163).
© Copyright 2020 Stratasys. All rights reserved.
Right and Left Side Panels
Figure 17 (page
159).
161).
162).
3
Page 162