Error Codes - ABB PickMaster Twin - PowerPac Applications Manual

7.5 Error codes

Common error codes
Error code
4097
4098
4099
4100
4101
4197
4198
4199
4200
4202
4203
4204
4205
4206
4207
4208
Application manual - PickMaster® Twin - PowerPac
3HAC064218-001 Revision: B
Type Description
Error Undefined error
Reason: The occurred error has not been given a correct error
ID but the error message should explain the reason.
Status Information only
Error Command line options
Reason: PickMaster was given an unknown command line
option, e.g. /p, at startup.
Error Description: Unexpected error
Reason: An unexpected error occurred in PickMaster. See
the log message for more information.
Error XML parsing error
Reason: There was a problem reading either a pmline or
pmproj file. See the log message for further information about
where in the file the error occurred.
Error The project has been upgraded to a later version and the file
is marked as modified. The file needs to be saved to make
changes permanent.
Error The line has been upgraded to a later version. If the line itself
was opened it is marked as modified and needs to be saved.
If a project was opened, the line should be opened and saved
before continuing.
Error The project file has an invalid format. It was either created
with a beta version of PickMaster or the file is corrupt.
Error The PickMaster program failed to access the Windows registry
when writing or reading its configuration
Warning The project is not designed on the current line. When trying
to open a project, there is already a project open that is built
upon a different line.
Reason: Only one line can be used at the same time.
Solution: Close any open projects and try to open the project
again.
Error Failed to load the corresponding line when opening a project.
The line file may be corrupt
Error Failed to load a line. The file may be corrupt.
Error The imported line may need to be recalibrated
Reason: If the imported line was designed with other cameras
or lenses, the cameras as well as the robot's base frame must
be recalibrated.
Error The selected RIS plug-in could not be loaded at program
startup. The file may be corrupt.
Error The selected RIS plug-in could not be found at program
startup.
Error One of the previously available lines has been overwritten by
another line. The old line will not show up as an available line
and projects designed on that line cannot be used.
© Copyright 2021 ABB. All rights reserved.
7 Troubleshooting
7.5 Error codes
Continues on next page
433