ABB PickMaster Twin - PowerPac Applications Manual page 32

2 Installation
2.5.2 Installing PickMaster Twin Client
Continued
Configuring local IP address
The local IP address should be reconfigured in the PickMaster Runtime (RRT) in
the following cases:
Start Runtime, click File - Options to open a pop-up dialog. Select the corresponding
interface in the list box and click OK.
Note that the network interface configurated in Runtime must be the IP address of
the local computer connected to the controller using WAN interface.
Use the following procedure to configure the local IP address in the PickMaster
Runtime (RRT):
Continues on next page
32
7 Choose an IP address for network adaptor configuration and click Next.
Note
To enable the time synchronization service, the user should select the local
IP address which is connected to the real controller during installing the
PickMaster Twin Client.
If the computer is not yet connected to a real controller, the IP address
could also be configured after the installation. For detailed information,
see Configuring local IP address on page
8 Click Next to start the installation.
9 When the installation is complete, choose to restart the computer now or
later and click Finish..
• Previous IP configuration during installation is wrong.
• The network interface currently used for connecting the real controller has
been changed.
1 Start Runtime.
2 Click File - Options to open a pop-up dialog.
xx2100000346
© Copyright 2021 ABB. All rights reserved.
32.
Application manual - PickMaster® Twin - PowerPac
3HAC064218-001 Revision: B