ABB PickMaster Twin - PowerPac Applications Manual page 177

Configuring the I/O
I/O signals
I/O signals are configured using RobotStudio or the FlexPendant. Then they can
be used from Runtime.
The predefined signals can be used without modifications. Edit the predefined
signals or add additional signals if needed.
Predefined I/O signals
The following I/O signals are predefined on delivery. Some of them are used or
referenced to when configuring the line. The encoder signals are described in
Application manual - Conveyor tracking.
I/O signal name
diX_1
doStartCnvX
doTrigVisX
doManSyncX
Application manual - PickMaster® Twin - PowerPac
3HAC064218-001 Revision: B
The Select Real Controller dialog is opened.
xx1800001715
3 In the dialog box, choose the real controller to be connected.
4 Click OK to apply the configuration.
5 Click Close to close the Edit Controller dialog.
Note
The maximum name length for a work area signal is 15 characters.
© Copyright 2021 ABB. All rights reserved.
4 Working with PickMaster PowerPac
Description
Digital input signals for custom use, such as generating I/O
triggered position or checking a gripper pressure switch.
Digital output for starting/stopping conveyors.
Digital output for triggering an image acquisition. This signal
is used by Runtime to order the camera to acquire an image.
Digital output used for triggering predefined positions in a
conveyor work area. This output should be connected to the
StartSig (input 9) on the corresponding encoder board.
4.3.1 Switching to real Runtime
Continued
Continues on next page
177