ABB PickMaster Twin - PowerPac Applications Manual page 443

Error code
12319
12321
12322
12323
12324
12325
12326
12329
12330
12331
12332
12333
12334
12337
12341
12342
Application manual - PickMaster® Twin - PowerPac
3HAC064218-001 Revision: B
Type Description
Error External model failed to inspect image.
Reason: See log message for more information
Error When the line was opened, more than one camera was
defined to use the same port on the same frame grabber.
Only one camera can be configured to use a single camera
port and hence the other cameras were reset and must be
configured again.
Error When the line was opened, a camera was defined on a frame
grabber that was not available. The camera was reset and
must be configured again.
Error Could not initiate the camera. More information is provided
in the log message.
Error Failed to save camera configuration. More information is
provided in the log message
Error Failed to load camera configuration. More information is
provided in the log message.
Error Failed to load vision model configuration. More information
is provided in the log message
Warning Failed to communicate with Gigabit Ethernet camera.
Reason: Bad Ethernet connection or excessive Ethernet
communication.
Warning Images are triggered too frequently.
Solution: Adjust vision models to be less time consuming, or
decrease trigger frequency.
Warning Connection to camera is lost, attempting to reconnect.
Reason: Ethernet cable or power cable has been disconnec-
ted.
Warning Image Buffer Full. More information is provided in the log
message.
Warning A Gigabit Ethernet camera was found, but no such license
was detected.
Reason: No USB stick with vision license is inserted in the
PC.
Warning A license for Gigabit Ethernet vision was detected, but no
such camera was found.
Reason: Camera is not connected, not turned on, or has an
invalid IP-address.
Warning Failed to read parameter from camera.
Reason: Check if the appropriate Cognex Drivers are installed.
If the problem persits, check network connections.
Status Cognex USB License dongle is attached.
Warning Cognex USB License dongle is removed.
© Copyright 2021 ABB. All rights reserved.
7 Troubleshooting
7.5 Error codes
Continued
443