ABB PickMaster Twin - PowerPac Applications Manual page 435

Error code
4306
4307
4308
4309
4310
4311
4312
4313
4314
4315
4319
4320
4321
4326
4327
4328
4329
4396
Application manual - PickMaster® Twin - PowerPac
3HAC064218-001 Revision: B
Type Description
Status A model was edited on a different camera than it was created
on.
Solution: Check that the correct camera is selected in the
position source and retrain the model.
Warning A vision model was created on a camera that has not been
calibrated.
Solution: Open the corresponding line and calibrate the
camera. Then retrain the model.
Error When running a project, a vision model found an object but
could not find the item or container to refer to.
Solution: Stop the project, remove the vision model in ques-
tion and create a new one for the correct item.
Warning A container is incorrectly configured.
Solution: Check the error message for more information.
Status Production was successfully started.
Status Production was successfully stopped.
Warning Indication that PickMaster is running on a demo license with
limited production time.
Reason: There is only a demo license installed
Solution: Request a fully qualified license to run projects for
an unlimited time.
Error PickMaster is running on a demo license and the allowed
production time is exceeded.
Solution: Request a fully qualified license or restart the Pick-
Master program to be able to start a project again
Error Got scene information from an unknown work area.
Status The work area that triggers a Position Source has changed.
This occurs at project startup or when the robot controller
with the previous trigger work area has stopped.
Warning Received item acknowledgment from an unknown work area.
Warning A project that used load balancing has been upgraded and a
work area order was generated. The work area order must
be verified in the Position Source configuration dialog box
Warning An item acknowledge was received from a work area but the
corresponding item position could not be found. Following
work areas will not be notified that an item position has
already been accessed.
Warning Item positions lost on work area due to missing strobe. For
more information, see
Warning Expected item positions missing from position source. For
more information, see
Warning Trigger/strobe time mismatch. Item positions from position
souce to work area lost. For more information, see
4326 - 4329 on page
Warning Trigger/strobe time mismatch. Strobe from work area was
ignored. For more information, see
page 424.
Error A COM error occurred in when using an External Sensor. The
log message provides more information.
© Copyright 2021 ABB. All rights reserved.
7 Troubleshooting
7.5 Error codes
Warnings 4326 - 4329 on page
Warnings 4326 - 4329 on page
424.
Warnings 4326 - 4329 on
Continues on next page
Continued
424.
424.
Warnings
435